Introduction

The front housing includes the motor, the chuck, and the gears. There's a good chance that whatever needs to be replaced will be found in here.

Pièces

Aucune pièce nécessaire.

  1. On the front of the drill, remove the three 2" flathead screws connecting the front housing to the rear housing.
    • On the front of the drill, remove the three 2" flathead screws connecting the front housing to the rear housing.

    Ajouter un commentaire

  2. Pull the front housing apart from the rear.
    • Pull the front housing apart from the rear.

    • The motor and gears might fall out when you are pulling it apart.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Matt

Membre depuis le 10/10/2010

365 Réputation

7 tutoriels rédigés

Équipe

Cal Poly, Team 5-17, Maness Fall 2010 Membre de l'équipe Cal Poly, Team 5-17, Maness Fall 2010

CPSU-MANESS-F10S5G17

3 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 84