Introduction

This a simple process requiring only a small Phillips screwdriver and a slim flathead.

Note: A few trays for the screws, a wristband and an anti-static surface mat are ideal for safe handling of sensitive electronics.

  1. - Remove battery.
    • - Remove battery.

    • - Remove memory tray door (1 Screw).

    • - Remove hard drive door (1 Screw).

    • - Remove hard drive (3 Screws).

    Ajouter un commentaire

  2. - Remove all screws from the bottom cover. There are three types of screws. Marked here with Red Circles, Red Squares and Orange Circles.
    • - Remove all screws from the bottom cover. There are three types of screws. Marked here with Red Circles, Red Squares and Orange Circles.

    Ajouter un commentaire

    • - Remove CD/DVD Drive by sliding it out.

    • - Remove three more screws, which were hiding under the DVD drive.

    Ajouter un commentaire

    • - Carefully remove the cover, by unpopping it with a slim flathead, slide it out away from the RJ-45, HDMI and VGA ports.

    Ajouter un commentaire

    • - The audio/usb interface card is now within reach. Just remove the two screws and carefully slide out the flat connector to remove the card.

    Ajouter un commentaire

    • - Fire up the air compressor and blow out dust from the fan and heatsinks.

    Ajouter un commentaire

    • - If you are replacing your RAM, simply unpop the four latches and slide out the memory sticks.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

5 autre(s) ont terminé cette réparation.

Artem Nikulkov

Membre depuis le 22/10/2010

232 Réputation

1 tutoriel rédigé

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 5

30 derniers jours : 15

Total : 20,410