Introduction
If you need to replace the collet nut or collet itself, this is the guide for you.
Ce dont vous avez besoin
-
-
Press the blue button and hold it down.
-
Unscrew the collet nut, with your fingers (as if you were going to change the bit).
-
Continue until the collet nut comes completely off of the Dremel.
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
7 autres ont terminé cette réparation.
2 commentaires
I easily removed the bit by holding the blue button and using the black wrench to loosen it and then I remove the silver piece that holds the bit then when I tried to use another one of the attachments it seems like it’s too large to fit in there I haven’t been able to use any of the other attachments like polishing and the finer little grinders