Réparez vos affaires Communauté Boutique

Drill Master Heat Gun Motor Replacement

Introduction

The motor inside the barrel of the gun powers the fan. Use this guide to replace the motor.

Ce dont vous avez besoin

  1. Drill Master Heat Gun Motor Replacement, Motor: étape 1, image 1 de 1

    • Be sure the heat gun is unplugged before starting this process.

    • Remove the seven 14mm screws from the side of the drill using the PH#0 screwdriver.

    • You will need a screwdriver extension.

    Traduire

  2. Drill Master Heat Gun Motor Replacement: étape 2, image 1 de 1

    • Remove the 8mm screw from underside of barrel using the PH#0 screwdriver.

    • Don't try to open the casing just yet.

    Traduire

  3. Drill Master Heat Gun Motor Replacement: étape 3, image 1 de 3 Drill Master Heat Gun Motor Replacement: étape 3, image 2 de 3 Drill Master Heat Gun Motor Replacement: étape 3, image 3 de 3

    • Remove the barrel casing on either end by twisting and pulling each side off.

    Traduire

  4. Drill Master Heat Gun Motor Replacement: étape 4, image 1 de 1

    • Remove the top casing to reveal inside of drill. You might have to tug a little harder for this one.

    Traduire

  6. Drill Master Heat Gun Motor Replacement: étape 5, image 1 de 1

    • Remove the metal casing and fan cover from the fan unit.

    Traduire

  7. Drill Master Heat Gun Motor Replacement: étape 6, image 1 de 1

    • Bend the metal prongs backward that connect the fan motor to the plastic cap.

    • Bending the brackets too far back can cause the brackets to break.

    Traduire

  8. Drill Master Heat Gun Motor Replacement: étape 7, image 1 de 1

    • Remove the plastic cap from the motor,

    • This will allow you to work only with the motor and fan.

    Traduire

  9. Drill Master Heat Gun Motor Replacement: étape 8, image 1 de 1

    • Remove the fan by pulling it from the motor rod.

    Traduire

  10. Drill Master Heat Gun Motor Replacement: étape 9, image 1 de 1

    • Remove the two 12mm screws from the plastic fan casing using PH#00

    Traduire

  11. Drill Master Heat Gun Motor Replacement: étape 10, image 1 de 1

    • Remove the plastic fan casing.

    Traduire

  12. Drill Master Heat Gun Motor Replacement: étape 11, image 1 de 1

    • Remove the metal casing from the motor and insert the new motor in its place.

    • You may have to tug a little.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Auteur

avec 4 autres contributeurs

Mikayla Kim

Membre depuis le 01/31/17

523 Réputation

5 tutoriels rédigés

Badges: 8

+ 5 badges supplémentaires

Équipe

University of North Texas, Team 1-2, Campbell Spring 2017 Membre de l'équipe University of North Texas, Team 1-2, Campbell Spring 2017

UNT-CAMPBELL-S17S1G2

3 membres

10 tutoriels rédigés

Un commentaire

Where can I find a new motor?

jstabler38 - Réponse

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 2

7 derniers jours : 4

30 derniers jours : 23

Total : 1,466