Aller au contenu principal

Introduction

Follow this guide to replace the rear panel on a Sony Dualshock 4 CHU-ZCT2U PlayStation controller.

  1. Use a Phillips screwdriver to remove the four 6.4 mm-long screws from the rear panel. Use a Phillips screwdriver to remove the four 6.4 mm-long screws from the rear panel.
    • Use a Phillips screwdriver to remove the four 6.4 mm-long screws from the rear panel.

  2. Insert an opening tool into the crease where the front and rear panel meet, starting from the outside edge of either handle. Gently pry the rear panel off of the front panel until they become partially separated.
    • Insert an opening tool into the crease where the front and rear panel meet, starting from the outside edge of either handle.

    • Gently pry the rear panel off of the front panel until they become partially separated.

  3. Use the opening tool to separate the panels by releasing the plastic clips around the perimeter of the controller. Use the opening tool to separate the panels by releasing the plastic clips around the perimeter of the controller. Use the opening tool to separate the panels by releasing the plastic clips around the perimeter of the controller.
    • Use the opening tool to separate the panels by releasing the plastic clips around the perimeter of the controller.

  4. Lift the rear panel directly away from the controller. Do not completely remove the rear panel. It is still attached to the controller by a ribbon cable.
    • Lift the rear panel directly away from the controller.

    • Do not completely remove the rear panel. It is still attached to the controller by a ribbon cable.

  5. Use your fingers to gently pull the ribbon cable straight out of its connector on the motherboard. Since this cable's pull tab is too small to grab with fingers or tweezers, grab the cable itself. Otherwise utilize pull tabs whenever possible.
    • Use your fingers to gently pull the ribbon cable straight out of its connector on the motherboard.

    • Since this cable's pull tab is too small to grab with fingers or tweezers, grab the cable itself. Otherwise utilize pull tabs whenever possible.

    • During reassembly, grab the ribbon cable by the blue tab and gently press the cable straight into the connector. Push the blue tab rather than the ribbon cable itself.

Conclusion

To reassemble your device, follow the above steps in reverse order.

Repair didn’t go as planned? Check out our Answers community for troubleshooting help.

Une autre personne a terminé cette réparation.

Sam Omiotek

Membre depuis le 25/02/2019

26 701 Réputation

180 tutoriels rédigés

Équipe

iFixit Membre de l'équipe iFixit

Community

137 membres

16 425 tutoriels rédigés

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 2

7 derniers jours : 8

30 derniers jours : 47

Total : 579