Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the six 13mm case screws with a #0 phillips screwdriver.
-
Separate the screwdriver housing with a plastic opening tool.
-
Remove battery casing half to expose screwdriver internals.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Locate battery
-
Remove battery, printed circuit board, LED, and motor assembly from screwdriver casing.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using side cutters, cut the red and black wires connecting the battery to the printed circuit board just after the shrink wrap tubing.
-
Strip the ends of the wires attached to the printed circuit board 1/4 inch above the ends of the cut wires.
-
Solder the new battery to the stripped wires attached to the printed circuit board.
-
Wrap the newly soldered connections with electrical tape.
-
Annulation : je n'ai pas terminé ce tutoriel.
2 autres ont terminé cette réparation.