Réparez vos affaires Communauté Boutique

Edwin the Duck Motherboard Replacement

Introduction

Edwin the interactive toy cannot work if the central most crucial part of Edwin, which is the motherboard, does not work. If there is water damage, and Edwin is no longer working, this guide will take you through the steps of replacing it.

Ce dont vous avez besoin

  1. Edwin the Duck Motherboard Replacement, Motherboard: étape 1, image 1 de 2 Edwin the Duck Motherboard Replacement, Motherboard: étape 1, image 2 de 2

    • Unscrew the four 9mm screws with a T8 screwdriver bit

    • Remove the back plate off

    Modifier

  2. Edwin the Duck Motherboard Replacement: étape 2, image 1 de 2 Edwin the Duck Motherboard Replacement: étape 2, image 2 de 2

    • Carefully take off the rubber skin.

    • Be patient and don't rush. You don't want to rip or damage the rubber skin resulting in losing the waterproof cover.

    Modifier

  3. Edwin the Duck Motherboard Replacement: étape 3, image 1 de 1

    • Using the J1 screwdriver bit, unscrew all six 9 mm screws that run along the border.

    Modifier

  5. Edwin the Duck Motherboard Replacement: étape 4, image 1 de 2 Edwin the Duck Motherboard Replacement: étape 4, image 2 de 2

    • Use the plastic opening tool to open the inside of the duck.

    • Be very careful when splitting the two halves apart. There are wires connecting to both sides. Remember to open slowly.

    Modifier

  6. Edwin the Duck Motherboard Replacement: étape 5, image 1 de 2 Edwin the Duck Motherboard Replacement: étape 5, image 2 de 2

    • Using the plastic opening tool pull up the black tab up until it stops.

    • Be careful not to pull up the black tab too far up, otherwise the cable won't be secure anymore.

    • Pull up the white cable tab, up slowly

    Modifier

  7. Edwin the Duck Motherboard Replacement: étape 6, image 1 de 1

    • Use the J1 screwdriver bit to unscrew all four 9 mm screws attached to the motherboard.

    Modifier

  8. Edwin the Duck Motherboard Replacement: étape 7, image 1 de 1

    • Remove the top connector as you see in the picture.

    • Replace the new motherboard and you are finished.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Auteur

avec 3 autres contributeurs

Caleb Kim

Membre depuis le 10/18/17

143 Réputation

1 tutoriel rédigé

Badges: 6

+ 3 badges supplémentaires

Équipe

UW Tacoma, Team S1-G4, Rose Fall 2017 Membre de l'équipe UW Tacoma, Team S1-G4, Rose Fall 2017

UWT-ROSE-F17S1G4

4 membres

8 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 5

Total : 397