To get to the inside parts of the printer, the housing components must come off.

  1. Turn off the printer.
    • Turn off the printer.

    • Disconnect all data connections coming into the printer such as USB, networkd cables, firewire, etc. as well as removing the power cord.

    Ajouter un commentaire

  2. Locate the IEEE cover in  the back.
    • Locate the IEEE cover in the back.

    • Gently slide cover to the right to unlatch then pull to remove it.

    Ajouter un commentaire

    • Using a #2 Phillips screwdriver, remove the four 10mm screws shown.

    • Remove the 6mm screw that holds the rear housing in place.

    Ajouter un commentaire

    • Remove the rear housing by pulling it backwards.

    Ajouter un commentaire

    • Insert the flathead screwdriver or plastic pry tool into the cutouts of the lower housing.

    • Release the two tabs of the side housing by lifting the tool in an upward motion

    • Remove the side housing by pulling it outwards.

    Ajouter un commentaire

    • Both side housings are attached by the same type of mechanism.

    • Using the same method, remove the other side housing.

    Ajouter un commentaire

    • Lift the paper support.

    • Open the printer cover and front cover.

    Ajouter un commentaire

    • Remove the four 10 mm Phillips #2 screws from the sides of the printer.

    • Remove the three 6mm Phillips #2 screws.

    Ajouter un commentaire

    • Detach the tabs from the pins on each side by pulling it outwards.

    Ajouter un commentaire

    • Remove the two 10 mm Phillips #2 screws on the front of the printer.

    Ajouter un commentaire

    • Disconnect the cable on the side by carefully pulling it outwards.

    • You may need to gently rock the cable up and down while pulling.

    Ajouter un commentaire

    • Remove the upper housing by lifting it upwards.

    • It's easier to lift the housing by gripping it from the bottom.

    Ajouter un commentaire


To reassemble your device, follow these instructions in reverse order.

5 autre(s) ont terminé cette réparation.

Larry Huang

Membre depuis le 12/10/2011

704 Réputation

4 tutoriels rédigés


Cal Poly, Team 17-11, Regan Fall 2011 Membre de l'équipe Cal Poly, Team 17-11, Regan Fall 2011


4 membres

6 tutoriels rédigés

Thank you so much, Larry! I am repurposing my 1400 for sublimation printing and need to get the print head a little easier than standard methods! Much appreciated!

ryan Caputo - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 5

30 derniers jours : 31

Total : 5,629