Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a Phillips #0 screwdriver to remove the four 21.7mm screws holding the back panel to the frame.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Once the screws are out, use a plastic opening tool or spudger to pry the top of the back panel open. There may be some resistance, but it will eventually pry loose.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Once the top is separated, use your hand to remove the back panel from the unit.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using tape or a post-it, label the input and output wires on the reverb. Remove these wires from the box.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the two female connection terminals from the speaker terminals.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a Philips #1 screwdriver to remove the four 21.9 mm Phillips screws from the perimeter of the speaker.
-
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.