Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Turn the multimeter so it is display side down.
-
Lift up the back stand of the device by putting your thumb in the curved well at the bottom of the device, so you have access to the two covered screws below.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use your Phillips #2 Screwdriver to remove the four black 21 mm Phillips #2 screws.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Turn the Fluke 77 Series III Multimeter back over so that it is display side up.
-
Pry the front panel from the back panel at the seam.
-
If the front panel does not come off easily, move a plastic opening tool along the seam until the panels separate completely.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Locate the 9V battery in the lower right corner of the device.
-
Pull the battery out of its terminal.
-
Annulation : je n'ai pas terminé ce tutoriel.
5 autres ont terminé cette réparation.