Introduction
The inside part of the interior dome light assembly is cracked.
Ce dont vous avez besoin
-
-
-
Remove the screw cover in the handle housing using a flathead screwdriver.
Demander à FixBot
-
-
-
Remove the screw that is holding the handle housing with a T20 Torx screwdriver.
-
-
-
Detach the wires on the handle housing with a flathead screwdriver by pushing upwards on the release slot.
-
-
-
-
Remove the cover on the door grip by prying gently with a flathead screwdriver.
-
-
-
Take off the inside door panel by removing all screws with a T20 Torx screwdriver.
-
-
-
Remove the two screws holding the handle bracket with a T20 Torx screwdriver.
-
-
-
Remove the outside door handle by prying gently with a flathead screwdriver to loosen, and then slide it back.
-
-
-
Detach the door latch rod from the handle bracket by pulling the plastic end out of the metal loop.
-
-
-
Pull the locking rod free from the handle bracket and remove the broken handle bracket.
-
-
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
6 autres ont terminé cette réparation.
Équipe
Michigan Tech, Team 1-11, Lauer Spring 2016 Membre de l'équipe Michigan Tech, Team 1-11, Lauer Spring 2016
MTU-LAUER-S16S1G11
1 membre
12 tutoriels rédigés
1 commentaire de tutoriel
Excellent guide. I should have watched the video before disassembly. Actually got part from coastal ford for $40. Same as napa but actual Ford part! And in stock. Thanks Glen
