Introduction
This repair guide will show you how to replace the motherboard on a Fossil Q Marshal Gen 2 smartwatch. Be careful not to damage the motherboard, wiring, or the metal connectors on your smartwatch.
Ce dont vous avez besoin
-
-
Squeeze retaining pins together to release chain from watch body. This can be done by hand or with tweezers.
-
Remove chain from opposing side of watch body.
-
-
-
-
The battery is secured to the back of the motherboard utilizing a sticky pad. Gently separate the battery from the board while making sure not to put too much stress on the board. This is best done at the location shown.
-
-
-
Using your finger remove the metal hooks from the black electronic housing.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
4 autres ont terminé cette réparation.