Introduction

Use this guide to replace the battery door.

Pièces

Aucune pièce nécessaire.

Locate and remove two 6.4mm screws on the bottom of the camera with a Phillips #00 screwdriver.
  • Locate and remove two 6.4mm screws on the bottom of the camera with a Phillips #00 screwdriver.

Ajouter un commentaire

Locate the battery door.
  • Locate the battery door.

Ajouter un commentaire

Locate the latch on the battery door.
  • Locate the latch on the battery door.

  • Use your finger pry to it open where it says "BATT."

Ajouter un commentaire

Remove the battery from the camera by pulling the battery door outward.
  • Remove the battery from the camera by pulling the battery door outward.

Ajouter un commentaire

Locate and remove three black 3.80mm screws on the back of the black casing with the Phillips #00 screwdriver.
  • Locate and remove three black 3.80mm screws on the back of the black casing with the Phillips #00 screwdriver.

Ajouter un commentaire

Squeeze the camera placing a thumb on the tab marked CE.
  • Squeeze the camera placing a thumb on the tab marked CE.

  • Pull the back half of the camera firmly away from the camera body.

Ajouter un commentaire

Locate and remove the 3.80mm screw that holds the plastic strip to the camera body with a Phillips #00 screwdriver. The plastic strip will now come off the camera body.
  • Locate and remove the 3.80mm screw that holds the plastic strip to the camera body with a Phillips #00 screwdriver.

  • The plastic strip will now come off the camera body.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Eric Nicolai

Membre depuis le 10/01/2011

679 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 13-5, Forte Winter 2011 Membre de l'équipe Cal Poly, Team 13-5, Forte Winter 2011

CPSU-FORTE-W11S13G5

5 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 3

Total : 1,641