Locate and remove two 6.4mm screws on the bottom of the camera with a Phillips #00 screwdriver.
  • Locate and remove two 6.4mm screws on the bottom of the camera with a Phillips #00 screwdriver.

Ajouter un commentaire

Locate the battery door.
  • Locate the battery door.

Ajouter un commentaire

  • Locate the latch on the battery door marked by the word "BATT." Use your finger to pry it open.

Ajouter un commentaire

  • Remove the battery from the camera by pulling the battery door outwards.

Ajouter un commentaire

  • Locate and remove three black 3.80mm screws on the back of the camera with the Phillips #00 screwdriver.

Ajouter un commentaire

  • Locate and remove the 6.4mm screws located on either side of the camera with a Phillips #00 screwdriver.

Ajouter un commentaire

  • Locate the film door latch located on the side of the camera.

  • Insert the spudger under the latch.

  • Caution: Be careful during the following step in order to not break any parts within the camera. Prying the latch in any other direction than perpendicular may result in broken parts.

  • Pry the latch upward, applying force perpendicular to the camera.

Ajouter un commentaire

  • Insert the flat edge of the spudger between the gold front casing and the black back casing.

  • Pry the spudger upward until the black back casing snaps out and is dislodged on that edge of the camera.

Ajouter un commentaire

  • Squeeze the camera by placing a thumb on the tab marked CE.

  • Pull the back half of the camera firmly away from the camera body.

Ajouter un commentaire

  • Locate and remove the 3.80mm screw inside the film compartment with the Phillips #00 screwdriver.

Ajouter un commentaire

  • Pull the front cover off of the camera by lifting the tripod tab over the tripod hole.

Ajouter un commentaire

  • Locate the film door on the bottom of the camera.

  • Locate the pin that connects the film door to the camera

Ajouter un commentaire

  • Push the pin from one side with the spudger until it comes out on the opposite side.

Ajouter un commentaire

  • Grab the pin with the tweezers and gently pull it out.

  • The film door should feel lose.

Ajouter un commentaire

  • Remove the door with your fingers and discard it.

  • Insert the replacement film door appropriately to fit where the broken door was located.

Ajouter un commentaire

Conclusion

To reassemble your device, follow the instructions from the "Disassembling Fujifilm Endeavor 100ix Outer Casing" guide in reverse order.

Eric Nicolai

Membre depuis le 10/01/2011

679 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 13-5, Forte Winter 2011 Membre de l'équipe Cal Poly, Team 13-5, Forte Winter 2011

CPSU-FORTE-W11S13G5

5 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 1,571