Introduction

The rear housing cover protects the back of the camera. If the rear housing cover is cracked or damaged, it should be replaced.

Pièces

Aucune pièce nécessaire.

Turn the camera upside down so you can access the battery chamber.
  • Turn the camera upside down so you can access the battery chamber.

  • Make sure that the camera is powered off before opening the battery chamber. Not doing so could damage your memory card.

Ajouter un commentaire

Push the battery chamber latch in the direction of the front of the camera.  Keeping tension on the latch, slide the battery chamber cover toward the outside of the camera, opening the battery chamber.
  • Push the battery chamber latch in the direction of the front of the camera. Keeping tension on the latch, slide the battery chamber cover toward the outside of the camera, opening the battery chamber.

Ajouter un commentaire

  • With the battery chamber open, remove the old batteries.

  • When replacing the batteries, remember that the battery orientation is shown by the + and - marks. Each mark indicates which side of the battery faces up in the chamber.

Ajouter un commentaire

  • Remove the 4mm JIS #00 screws from the sides and bottom of the camera.

Ajouter un commentaire

  • Carefully pry away the rear housing cover with the plastic opening tool.

Ajouter un commentaire

  • Remove the rear housing cover by carefully pulling it away from the camera.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Marcos

Membre depuis le 20/01/2015

101 Réputation

1 tutoriel rédigé

Équipe

USF Tampa, Team 7-1, Remmell Winter 2015 Membre de l'équipe USF Tampa, Team 7-1, Remmell Winter 2015

USFT-REMMELL-W15S7G1

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 6

Total : 541