Danger
Potentiellement dangereux
Risque de blessure si cette procédure n'est pas suivie correctement. Faites preuve de prudence et suivez tous les avertissements.
Danger

Introduction

Take caution as to not touch both ends of the capacitor, or any exposed ends of wire that are connected to such. The capacitor stores a large amount of charge, and could shock you. You will need a soldering station and something to remove old solder, such as a desoldering pump or a solder wick.

Remove the six 4.5 mm #00 Phillips screws from the bottom, left, and right sides.
  • Remove the six 4.5 mm #00 Phillips screws from the bottom, left, and right sides.

Ajouter un commentaire

Use a spudger to remove the film slot guard on the top of the camera.
  • Use a spudger to remove the film slot guard on the top of the camera.

  • Remove the one 4.5 mm #00 Phillips screw under the slot guard.

Ajouter un commentaire

  • Press the release tab on the back of the camera to open the film compartment.

  • Remove the film cartridge within this compartment.

Ajouter un commentaire

  • Press the battery cover in and down to remove it.

  • Remove any batteries within.

Ajouter un commentaire

  • Use a plastic opening tool to help pry the front and back shells apart.

  • With the camera facing down, remove only the back shell.

Ajouter un commentaire

  • Carefully peel the front side of the shell away.

    • As you lift the front shell, be careful to not pull too hard since there is a spring attached to the shell and the camera body.

  • Using a set of tweezers, detach the spring from the body. The spring will retract into the black and gray ring on the front shell.

Ajouter un commentaire

  • Remove the four 4.5 mm screws inside the battery holder with a long #00 Phillips screwdriver.

Ajouter un commentaire

  • Gently pull on the battery holder to remove it from the case, exposing the capacitor.

  • Pull up on the backside of the capacitor to remove it from the battery holder.

    • The capacitor will have a small amount of adhesive holding it onto the battery holder. Keep this intact, but don't worry if it is damaged.

    • Be careful not to touch the wire leads on the front of the capacitor, as you could get shocked.

Ajouter un commentaire

  • Desolder the ends of the wires from the leads of the capacitor to remove it.

  • Take note of the connections between the wires and leads for reassembly. The brown wire connects to side with white line and the white wire connects to the other side.

  • Be careful not to touch both leads of the capacitor with your soldering iron. This will bridge the connection and could create a spark.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jeffery

Membre depuis le 28/03/2015

217 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team S18-G6, Livingston Spring 2018 Membre de l'équipe Cal Poly, Team S18-G6, Livingston Spring 2018

CPSU-LIVINGSTON-S18S18G6

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 49