Introduction

In this guide you will need two tools: a Phillips #00 screwdriver and a soldering iron. Take caution when taking out the bulb especially if the capacitor is in tact, you may get shocked if you touch it.

Remove the six 4.5 mm #00 Phillips screws from the bottom, left, and right sides.
  • Remove the six 4.5 mm #00 Phillips screws from the bottom, left, and right sides.

Ajouter un commentaire

Use a spudger to remove the film slot guard on the top of the camera.
  • Use a spudger to remove the film slot guard on the top of the camera.

  • Remove the one 4.5 mm #00 Phillips screw under the slot guard.

Ajouter un commentaire

  • Press the release tab on the back of the camera to open the film compartment.

  • Remove the film cartridge within this compartment.

Ajouter un commentaire

  • Press the battery cover in and down to remove it.

  • Remove any batteries within.

Ajouter un commentaire

  • Use a plastic opening tool to help pry the front and back shells apart.

  • With the camera facing down, remove only the back shell.

Ajouter un commentaire

  • Carefully peel the front side of the shell away.

    • As you lift the front shell, be careful to not pull too hard since there is a spring attached to the shell and the camera body.

  • Using a set of tweezers, detach the spring from the body. The spring will retract into the black and gray ring on the front shell.

Ajouter un commentaire

  • Once the shell is off, remove the one 6.5 mm screw that is attached to the flash bulb using a Phillips #00 screwdriver.

Ajouter un commentaire

  • Remove the flash bulb from the circuit board by shifting it towards the side with the motor and lifting.

Ajouter un commentaire

  • Place the bulb over an open surface and use the soldering gun to melt the three connections off the bulb.

  • During reassembly, use the picture to attach the correct wire to the correct connection on the bulb (white-right, gray-top, brown-left).

Ajouter un commentaire

  • The flash bulb should now be detached completely from the circuit board.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jonnah Lee

Membre depuis le 18/04/2018

449 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team S18-G6, Livingston Spring 2018 Membre de l'équipe Cal Poly, Team S18-G6, Livingston Spring 2018

CPSU-LIVINGSTON-S18S18G6

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 4

30 derniers jours : 16

Total : 59