Introduction

This guide instructs you on how to replace the motor that ejects the film. You will need a Phillips screwdriver and a soldering iron.

Remove the six 4.5 mm #00 Phillips screws from the bottom, left, and right sides.
  • Remove the six 4.5 mm #00 Phillips screws from the bottom, left, and right sides.

Ajouter un commentaire

Use a spudger to remove the film slot guard on the top of the camera.
  • Use a spudger to remove the film slot guard on the top of the camera.

  • Remove the one 4.5 mm #00 Phillips screw under the slot guard.

Ajouter un commentaire

  • Press the release tab on the back of the camera to open the film compartment.

  • Remove the film cartridge within this compartment.

Ajouter un commentaire

  • Press the battery cover in and down to remove it.

  • Remove any batteries within.

Ajouter un commentaire

  • Use a plastic opening tool to help pry the front and back shells apart.

  • With the camera facing down, remove only the back shell.

Ajouter un commentaire

  • Carefully peel the front side of the shell away.

    • As you lift the front shell, be careful to not pull too hard since there is a spring attached to the shell and the camera body.

  • Using a set of tweezers, detach the spring from the body. The spring will retract into the black and gray ring on the front shell.

Ajouter un commentaire

  • Remove the four 4.5 mm #00 Phillips screws on the battery compartment.

Ajouter un commentaire

  • Lift up the battery compartment to free up the motor.

Ajouter un commentaire

  • Unscrew the two 2.9mm Phillips #00 screws holding the motor to the frame.

Ajouter un commentaire

  • Remove the motor from the frame.

Ajouter un commentaire

  • Desolder the wires from the leads of the capacitor.

  • Take note of the connections between the wires and leads for reassembly.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jeffery

Membre depuis le 28/03/2015

217 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team S18-G6, Livingston Spring 2018 Membre de l'équipe Cal Poly, Team S18-G6, Livingston Spring 2018

CPSU-LIVINGSTON-S18S18G6

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 2

30 derniers jours : 13

Total : 70