Fujifilm X-M1 Back Case Replacement

Introduction

Use this guide to replace a damaged back case, or open the case to access other components of your camera.

We highly suggest you use a magnetic project mat or an organization tray. This camera has many different types of screws and keeping them organized is key to proper reassembly.

Ce dont vous avez besoin

Étape 1 Battery

Fujifilm X-M1 Back Case Replacement, Battery: étape 1, image 1 de 2

Fujifilm X-M1 Back Case Replacement, Battery: étape 1, image 2 de 2

Turn the camera upside down to locate the battery compartment.
Slide the button up to open the compartment.
Slide the orange button up to release the battery.
The battery is not shown in these photos.

Modifier

Étape 2 Back Case

Fujifilm X-M1 Back Case Replacement, Back Case: étape 2, image 1 de 1

Remove the six 2.5 mm Phillips screws from the bottom of the camera.

Modifier

Étape 3

Use tweezers or a finger nail to peel back the rubber cover on the left handgrip.
Remove the 3.4 mm Phillips screw.
Remove the 3.7 mm screw.

Modifier

Étape 4

Use tweezers or a fingernail to peel back the rubber cover on the right handgrip.
Remove the 3.2 mm Phillips screw.
Remove the 3.8 mm Phillips screw.
Remove the 2.8 mm Phillips screw.

Modifier

Étape 5

Use tweezers to slide the metal shield straight out of the external flash mount.

Modifier

Étape 6

Fujifilm X-M1 Back Case Replacement: étape 6, image 3 de 3

Remove the four 4.6 mm Phillips screws from the external flash mount.
Use tweezers or two fingers to remove the mount clip.

Modifier

Étape 7

Extend the LCD.
Remove the two black 4.3 mm Phillips screws from the back case.

Modifier

Étape 8

Use two fingers to peel back and remove the black plastic cover from behind the LCD.

Modifier

Étape 9

Fujifilm X-M1 Back Case Replacement: étape 9, image 3 de 3

Slowly pull the back frame away from the camera.
Do not attempt to remove the frame, as it is attached to the camera by a ribbon cable.
Use tweezers to pull the white and blue ribbon cable out of the connector.

Modifier

Étape 10

Slide the frame around the LCD to remove it from the camera.

Modifier

Étape 11

Remove the two 2.6 mm Phillips screws from the right side of the metal frame.

Modifier

Étape 12

Use tweezers to unhook the speaker near the left handgrip.

Modifier

Étape 13

Slowly lift the metal frame away from the motherboard.
Do not attempt to remove the frame, as it is attached to the motherboard by a large ribbon cable.
Use tweezers to remove the plastic covering the motherboard.

Modifier

Étape 14

Fujifilm X-M1 Back Case Replacement: étape 14, image 3 de 3

To remove the ribbon cable, flip back the orange lock on the large ZIF connector with the flat end of a spudger.
If the ribbon cable does not pop out on its own, use tweezers to pull it out of the connector.
Remove the back case.