Introduction

We will walk through removal the USB port from the Fujitsu Lifebook Stylistic Q584.

Remove the white sticker covering the screws (if applicable)
  • Remove the white sticker covering the screws (if applicable)

  • Use the PH1 screwdriver to remove the four 2 mm screws from the the backside of the device.

Ajouter un commentaire

Insert the plastic opening tool along seam of back case.
  • Insert the plastic opening tool along seam of back case.

  • Gently slide the plastic opening tool along entire seam popping the clips free.

Ajouter un commentaire

  • Carefully lift the back case and remove smartcard ribbon from motherboard.

Ajouter un commentaire

  • Remove the ten 3mm screws with a PH00 screwdriver from the shield.

Ajouter un commentaire

  • Remove the grey docking station port cover

Ajouter un commentaire

  • Gently slide the plastic opening tool along entire seam popping the clips free.

Ajouter un commentaire

  • Lift the shield away from the device and remove the fingerprint scanners ribbon from the motherboard.

Ajouter un commentaire

  • Remove 2mm screw with a PH1 screwdriver from USB board

Ajouter un commentaire

  • Disconnect USB periphery ribbon from motherboard

Ajouter un commentaire

  • Pull USB board up to remove.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Spencer Bacon

Membre depuis le 21/09/2017

401 Réputation

4 tutoriels rédigés

Équipe

Washington State, Team S1-G3, Phelps-Hillen Fall 2017 Membre de l'équipe Washington State, Team S1-G3, Phelps-Hillen Fall 2017

WSU-PHELPS-HILLEN-F17S1G3

5 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 45