Pièces

Aucune pièce nécessaire.

Locate and remove the 14.5 mm Phillips #1 screw on the bottom of the fan base.
  • Locate and remove the 14.5 mm Phillips #1 screw on the bottom of the fan base.

Ajouter un commentaire

Locate the gray base support release tabs found on either side pictured in the first image.
  • Locate the gray base support release tabs found on either side pictured in the first image.

    • There are release tabs on each side of the base.

  • Press both release tabs in with the tip of your fingers and pull the gray base support until the tabs are cleared.

Ajouter un commentaire

  • Continue removing the gray base support by pressing your thumb into the circular opening in the base and pulling with your figures on the back side.

  • Notice that on the internal front tip of the base there is a tab. Because of this tab the back end will pivot off at that point.

Ajouter un commentaire

  • After the base has separated more it will be easy to fully remove it. Continue pulling the back edge of the gray base support, rotating it around the front tab until it comes off completely.

Ajouter un commentaire

  • Remove the following five 14.5 mm Phillips #1 screws found on the bottom.

    • All of the screws are recessed by 17.5 mm, so ensure your screwdriver can reach that far.

Ajouter un commentaire

  • Once all five screws have been removed the base cover should fall right off with out any effort.

  • When putting the base cover back on; be careful to make sure that none of the wires are pinched.

Ajouter un commentaire

  • Remove the two 10 mm Phillips #1 screws found connecting the switch to the case.

  • Notice the AC power cord line (white wire) goes into the switch under the [Off] button

Ajouter un commentaire

  • Take the 1.5 mm Flathead Screwdriver, or any thin elongated tool that fits into the semi-circular holes along side the wires. Press into the hole gently to release the grip on the wires.

    • The wires should release with ease if done properly.

  • When reassembling; skip this step.

Ajouter un commentaire

  • Take the new switch, and simply push the wiring into the correct holes:

    • AC Power Cord (white wire)

    • Low speed (gray wire)

    • Medium speed (orange wire)

    • High speed (red wire)

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Alan Su

Membre depuis le 03/10/2012

531 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 24-28, Regan Fall 2012 Membre de l'équipe Cal Poly, Team 24-28, Regan Fall 2012

CPSU-REGAN-F12S24G28

4 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 25

Total : 2,009