Introduction

This guide explains how to replace the speaker in a first-generation Nintendo Game Boy system.

Vidéo d'introduction

Switch your Game Boy off and remove the cartridge.
  • Switch your Game Boy off and remove the cartridge.

Ajouter un commentaire

Use a fingernail (or small coin) to push down on the battery door latch and remove the battery door.
  • Use a fingernail (or small coin) to push down on the battery door latch and remove the battery door.

    • The release latch is a plastic spring clip. If your Game Boy is getting on in years, be careful as the plastic may be brittle.

    • When you're replacing the cover, be sure to get its two plastic tabs into the slots in the bottom of the battery compartment before pushing the cover back in place.

Ajouter un commentaire

  • Use a fingernail to pry each battery outward from the positive (+) terminal to remove them.

    • Dispose of used batteries properly!

    • Remove the batteries from your Game Boy before storing it for more than a month or so.

Ajouter un commentaire

  • Remove the six Triwing screws from the back of the device.

Ajouter un commentaire

  • Gently separate the device's front casing from the back casing after you remove the screws.

    • Be careful not to completely separate the casing halves, as they are still joined by a large ribbon cable that may be damaged.

Ajouter un commentaire

  • Slide the front side of the casing down to expose the ribbon cable connector.

Ajouter un commentaire

  • Grip the ribbon connector with your thumb and forefinger. Pull down gently until the connector, not the ribbon itself, comes out of its socket.

  • Separate the front and back casings.

Ajouter un commentaire

  • Remove the 10 Phillips #00 screws from the motherboard.

Ajouter un commentaire

  • Use a plastic opening tool to gently lift the motherboard up and remove it from the front plastic case.

  • Use caution when lifting the board since the speaker is attached.

Ajouter un commentaire

  • Desolder the two wires connecting the speaker to the motherboard.

  • Remove the speaker.

  • If you're new to soldering, refer to this guide for tips that will help with desoldering the speaker wires and/or soldering the new ones in place.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 autre(s) ont terminé cette réparation.

Andrew Tramposch

Membre depuis le 24/06/2010

1 499 Réputation

11 tutoriels rédigés

Équipe

Cal Poly, Team 3-2, Johann Summer 2010 Membre de l'équipe Cal Poly, Team 3-2, Johann Summer 2010

CPSU-JOHANN-R10S3G2

3 membres

11 tutoriels rédigés

This is just a guide to remove the speaker not replacing it so change the title as it is misleading as people that following this will want know how to replace not remove only

Paul - Réponse

As stated in the conclusion, you simply follow the steps in reverse to install your replacement speaker.

Jeff Suovanen -

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 18

30 derniers jours : 112

Total : 18,367