Introduction

This guide will give you step-by-step instructions on how to quickly swap out that old battery for a new one.

Remove the five 7mm screws with H1.3 hex screwdriver.
  • Remove the five 7mm screws with H1.3 hex screwdriver.

Why is a H1.3 being used here when the screws look like TORX?

Stuart Kerr - Réponse

Use a plastic opening tool to remove the face of the device to expose the inner components.
  • Use a plastic opening tool to remove the face of the device to expose the inner components.

    • There is one metal piece at the top of the face that is loose. This is the GPS antenna which will need to be removed as well.

    • Be careful with the ribbon that connects the motherboard to the display.

Ajouter un commentaire

  • Proceed to disconnect the ribbon from the motherboard using tweezers.

Ajouter un commentaire

  • Using a T5 screwdriver, remove the two 5mm screws.

    • The motherboard should now move freely.

Ajouter un commentaire

  • Another ribbon is attached to the top of the motherboard. Disconnect this ribbon.

Ajouter un commentaire

  • Disconnect wires connecting battery to motherboard.

Ajouter un commentaire

  • The battery is glued to the motherboard and will need pried off using the nylon spudger.

Ajouter un commentaire

  • Now attach the new battery with adhesive and reassemble.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Victor Tanguy

Membre depuis le 26/03/2018

261 Réputation

1 tutoriel rédigé

Équipe

IUPUI, Team S1-G6, Harley Spring 2018 Membre de l'équipe IUPUI, Team S1-G6, Harley Spring 2018

IUPUI-HARLEY-S18S1G6

3 membres

2 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 16

7 derniers jours : 164

30 derniers jours : 649

Total : 1,346