Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the barcode sticker at the bottom of the device.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove two 8.4 mm T5 screws from the bottom of the device.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using a plastic opening tool, carefully pry open the device.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Unscrew the four 6.70 mm screws holding the motherboard in place using a philips #0 screw driver.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lift up the motherboard.
-
Carefully disconnect the battery and motherboard. Slowly wiggling the connection makes it easier to disconnect the battery from the motherboard.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using the plastic opening tool as a wedge, pry the battery from the case. This can be fairly tough as the battery is glued to the case. Don't be afraid to use force and some good leverage.
-
Annulation : je n'ai pas terminé ce tutoriel.
15 autres ont terminé cette réparation.
9 commentaires
Thanks for the guide. Used it to open up a Nuvi 265 because the battery had been left to discharge below the protection circuit's limit. Connected the battery leads (Green = ground, Red = voltage, Black = temperature) to a 5v USB charger for ~20 seconds to revive the protection circuit, and the unit is now charging again. If you're going to do this, know the risks. Thermal runaways in lithium batteries can be extremely volatile.