Introduction

If your speaker is defective, obtain a new speaker and replace the old one with the new working speaker.

  1. Remove the barcode sticker at the bottom of the device.
    • Remove the barcode sticker at the bottom of the device.

    Ajouter un commentaire

  2. Remove two 8.4 mm T5 screws from the bottom of the device.
    • Remove two 8.4 mm T5 screws from the bottom of the device.

    Ajouter un commentaire

    • Using a plastic opening tool, carefully pry open the device.

    • Open the device carefully, making sure not to damage the gold ribbon cable that connects the screen to the motherboard.

    turn the unit around

    Andrew Hayden - Réponse

    Since there is no replacement speaker whats the point of this process?

    greg - Réponse

    Very detailed set of instructions! Does anyone known the thread size of the screws in step 2? 8.4 mm T5 screws: is the length of the screw (8.4 mm) ,and the head specification (T5- size of screw driver). I need the actual thread specification. I lost one of the screws and the other one 's head is stripped. I need to replace both screws.

    Harold Schultz - Réponse

  3. Livraison gratuite pour les commandes de plus de 20 $
    Indiquez le code BLUEANDBLACK au moment de payer
    Livraison gratuite pour les commandes de plus de 20 $
    Indiquez le code BLUEANDBLACK
    • Remove the power button.

    Where can I buy the button

    milosvalek - Réponse

    • Unscrew the four 6.70 mm screws holding the motherboard in place using a philips #0 screw driver.

    Ajouter un commentaire

    • Lift up the motherboard.

    • Carefully disconnect the battery and motherboard. Slowly wiggling the connection makes it easier to disconnect the battery from the motherboard.

    Ajouter un commentaire

    • Using the plastic opening tool as a wedge, pry the battery from the case. This can be fairly tough as the battery is glued to the case. Don't be afraid to use force and some good leverage.

    Ajouter un commentaire

    • Carefully disconnect the speaker from the motherboard. Slowly wiggling the connection makes it easier to disconnect.

    Ajouter un commentaire

    • Using a plastic opening tool, wedge the speaker away from the device. The speaker is glued to the case so use force and leverage.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Timothy

Membre depuis le 26/01/2012

35 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 9-3, Regan Winter 2012 Membre de l'équipe Cal Poly, Team 9-3, Regan Winter 2012

CPSU-REGAN-W12S9G3

5 membres

4 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 3

Total : 3,702