Introduction

This device can be identified utilizing the criterion on the device page. When replacing the screen, be sure to set aside the following tools: T5 Torx screwdriver and plastic opening tool.

Pièces

Aucune pièce nécessaire.

Carefully remove model/serial number sticker.
  • Carefully remove model/serial number sticker.

Ajouter un commentaire

Remove two 4mm T5 Torx screws located under the sticker.
  • Remove two 4mm T5 Torx screws located under the sticker.

Ajouter un commentaire

  • Once the screws are removed, use the plastic opening tool to carefully separate the body from the screen encasing.

Ajouter un commentaire

  • Once the body of the nüvi is separated, carefully flip the tabs on the motherboard that secure the ribbon cable to the motherboard and disconnect.

Ajouter un commentaire

  • Use a plastic opening tool to loosen the three clips located on the top of the screen encasing to a position that loosens the hold on the screen.

Ajouter un commentaire

  • Use a plastic opening tool to loosen the two clips on the short sides of the Nuvi screen encasing to a position that allows the removal of the screen.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Hunter Johnson

Membre depuis le 27/03/2018

315 Réputation

2 tutoriels rédigés

Équipe

IUPUI, Team S3-G5, Harley Spring 2018 Membre de l'équipe IUPUI, Team S3-G5, Harley Spring 2018

IUPUI-HARLEY-S18S3G5

3 membres

2 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 8

Total : 101