1. Use a plastic spudger tool to remove the plastic frame.
    • Use a plastic spudger tool to remove the plastic frame.

    • Insert the tool into the groove in the center of the top of the outer frame and lever it gently until it pops out.

    Ajouter un commentaire

  2. Use a phillips head screw driver to remove all four screws in the corners around the screen.
    • Use a phillips head screw driver to remove all four screws in the corners around the screen.

    • Set the screws aside for later.

    Ajouter un commentaire

    • Gently pull from both ends to separate the front panel from the back.

    • Do not force the pieces apart wider than the length of the connecting wires or you will damage the wiring.

    Ajouter un commentaire

    • Locate the white wire clip. Gently unplug it using either your fingers or tweezers.

    Ajouter un commentaire

    • Carefully expose both halves of the device.

    • Be sure to not pull the two halves apart too hard to avoid damaging the black wire.

    Ajouter un commentaire

Conclusion

Your device should be ready to use once more.

2 autre(s) ont terminé cette réparation.

Adrian Leon

Membre depuis le 07/10/2010

169 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 22-1, Maness Fall 2010 Membre de l'équipe Cal Poly, Team 22-1, Maness Fall 2010

CPSU-MANESS-F10S22G1

3 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 1,780