Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Introduction

Before you begin disassembling the device, be sure the power is off.

  1. Wedge a plastic opening tool in between the outer frame and the rear panel assembly. Pry the outer frame off the perimeter of the rear panel assembly.
    • Wedge a plastic opening tool in between the outer frame and the rear panel assembly.

    • Pry the outer frame off the perimeter of the rear panel assembly.

    • The cover will easily pop off.

  2. OUVRIR TOUS LES ONGLETS

    Kits de mise à jour de RAM pour Mac

    Voir les kits

    Assez de RAM
    pour ouvrir tous les onglets

    Voir les kits
  3. Remove the four #00 Phillips screws securing the front case assembly to the rear case assembly. Carefully lift, but do not completely separate, the front case assembly from the rear case assembly.
    • Remove the four #00 Phillips screws securing the front case assembly to the rear case assembly.

    • Carefully lift, but do not completely separate, the front case assembly from the rear case assembly.

    • Be extremely cautious when separating both halves, as the rear case assembly is still attached to the front case assembly via a few connectors.

  4. Gently pull the battery cable connector from its socket on the motherboard.
    • Gently pull the battery cable connector from its socket on the motherboard.

    • The second connector can remain attached to the motherboard, but be careful not to break the connector while handling both halves of the device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Andrew Burman

Membre depuis le 18/01/2012

1 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 11-19, Maness Winter 2012 Membre de l'équipe Cal Poly, Team 11-19, Maness Winter 2012

CPSU-MANESS-W12S11G19

4 membres

4 tutoriels rédigés

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 1,306