Introduction

You will remove the back cover, remove screws from the fan and heat sink, and take out the fan from the laptop.

Pièces

Aucune pièce nécessaire.

Place the laptop so the back cover is facing up.
  • Place the laptop so the back cover is facing up.

Ajouter un commentaire

Remove the 8 screws from the back cover using the Phillips #00 screwdriver.
  • Remove the 8 screws from the back cover using the Phillips #00 screwdriver.

Ajouter un commentaire

  • Lift off the cover.

Ajouter un commentaire

  • Unplug the fan’s power cable, which is a group of black wires attached to a white plastic head on the motherboard.

  • Pull the plastic part of the cable, not the wires, so that the plug does not break.

Ajouter un commentaire

  • Remove the two screws located on opposite sides of the fan with a Phillips #00 screw driver.

Ajouter un commentaire

  • The fan is permanently attached to the silver heat sink next to the RAM.

  • To completely remove the parts, loosen the heat sink’s four screws with a Phillips #00 screw driver.

  • Take out the screws in the numerical order shown on the heat sink.

Ajouter un commentaire

  • Pull the fan and heat sink toward you at a 20 degree angle upward.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Toni Pipes

Membre depuis le 05/10/2010

297 Réputation

7 tutoriels rédigés

Équipe

Cal Poly, Team 21-31, Regan Fall 2010 Membre de l'équipe Cal Poly, Team 21-31, Regan Fall 2010

CPSU-REGAN-F10S21G31

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 10

Total : 4,606