Réparez vos affaires Communauté Boutique

General Pipe Cleaners Drain Cleaner PMEBO 2016 Reverse Switch Replacement

Introduction

Use this guide to replace the reverse switch in a General Pipe Cleaners Drain Cleaner PMEBO 2016.

Ce dont vous avez besoin

  1. General Pipe Cleaners Drain Cleaner PMEBO 2016 Reverse Switch Replacement, Reverse Switch: étape 1, image 1 de 1

    • Before you begin, make sure the drain cleaner is disconnected from power.

    • Use a Phillips #2 driver to remove the two screws securing the control box cover.

    Modifier

  2. General Pipe Cleaners Drain Cleaner PMEBO 2016 Reverse Switch Replacement: étape 2, image 1 de 1

    • Remove the control box cover.

    Modifier

  3. General Pipe Cleaners Drain Cleaner PMEBO 2016 Reverse Switch Replacement: étape 3, image 1 de 1

    • Use a 9/16 inch deep socket and ratchet to remove the nut securing the reverse switch.

    Modifier

  5. General Pipe Cleaners Drain Cleaner PMEBO 2016 Reverse Switch Replacement: étape 4, image 1 de 1

    • Remove the reverse switch guard.

    Modifier

  6. General Pipe Cleaners Drain Cleaner PMEBO 2016 Reverse Switch Replacement: étape 5, image 1 de 2 General Pipe Cleaners Drain Cleaner PMEBO 2016 Reverse Switch Replacement: étape 5, image 2 de 2

    • Squeeze the tabs on either side of the reverse switch connector.

    • Pull the two halves of the connector apart to disconnect it.

    • Take note of where everything is connected in the control box before disconnecting anything else.

    Modifier

  7. General Pipe Cleaners Drain Cleaner PMEBO 2016 Reverse Switch Replacement: étape 6, image 1 de 2 General Pipe Cleaners Drain Cleaner PMEBO 2016 Reverse Switch Replacement: étape 6, image 2 de 2

    • Pull the white cable straight off of its spade connector on the power switch diaphragm.

    Modifier

  8. General Pipe Cleaners Drain Cleaner PMEBO 2016 Reverse Switch Replacement: étape 7, image 1 de 2 General Pipe Cleaners Drain Cleaner PMEBO 2016 Reverse Switch Replacement: étape 7, image 2 de 2

    • Pull the black cable straight off of its spade connector on the power switch diaphragm.

    Modifier

  9. General Pipe Cleaners Drain Cleaner PMEBO 2016 Reverse Switch Replacement: étape 8, image 1 de 3 General Pipe Cleaners Drain Cleaner PMEBO 2016 Reverse Switch Replacement: étape 8, image 2 de 3 General Pipe Cleaners Drain Cleaner PMEBO 2016 Reverse Switch Replacement: étape 8, image 3 de 3

    • Slide the switch assembly down out of its hole in the control box and pull it out of the control box.

    • Be careful not to snag the switch on any cables during removal.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

Adam O'Camb

Membre depuis le 04/11/15

196 689 Réputation

416 tutoriels rédigés

Badges: 39

+ 36 badges supplémentaires

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 13

Total : 520