George Foreman GRS040BC Disassembly

Open the lid of the grill.

Remove the two 10 mm screws that secure the left hinge to the top panel of the grill using a Phillips #2 screwdriver.

Remove the two 10 mm screws that secure the right hinge to the top panel of the grill using a Phillips #2 screwdriver.

Remove the four 10mm screws that secure the top grill tray to the black backing using a Phillips #2 screwdriver.

Gently remove the top grill panel from the back casing to reveal the wiring and heating system.

Remove the two 5mm screws from the thermistor using a Phillips #2 screwdriver.

Remove the thermistor.

Remove the three 7.5 mm screws found on the black covering.

Take the cover off to show the lights.

Close your partially disassembled George Foreman and turn it upside down.

Pry out the two rubber supports.

Lift the back stand on the bottom of the device.

Remove the four 10mm screws found deep beneath the rubber supports and in the opposite corners.

Gently open the bottom case, taking caution not to mix up or break any wires.

Remove the 5mm screw connecting the white cable to the grill.

Remove the two 12mm screws found on the casing under the black stand using a TR6 Torx screwdriver.

Remove the casing and the stand, which will clip off, to reveal the wiring.