Réparez vos affaires Communauté Boutique

GoPro HD Hero2 Rear Case Replacement

Conditions préalables uniquement
Ce tutoriel est uniquement destiné à être utilisé comme prérequis d'autres tutoriels. Il ne se suffit pas à lui-même.

Introduction

This guide is a prerequisite for removing the mini HDMI port or replacing the rear case.

Ce dont vous avez besoin

  1. GoPro HD Hero2 Rear Case Replacement, Rear Case: étape 1, image 1 de 1

    • Remove the four Phillips #00 screws securing the rear case to the rest of the device:

    • Two 5.5 mm coarse thread screws.

    • Two 4.4 mm fine thread screws.

    Traduire

  2. GoPro HD Hero2 Rear Case Replacement: étape 2, image 1 de 2 GoPro HD Hero2 Rear Case Replacement: étape 2, image 2 de 2

    • Slide the edge of a plastic opening tool underneath the sticker on the rear cover and gently peel the sticker up.

    • Once you have enough of the sticker peeled up with the plastic opening tool, grab an edge of it with your fingers and pull it off completely.

    Traduire

  4. GoPro HD Hero2 Rear Case Replacement: étape 3, image 1 de 2 GoPro HD Hero2 Rear Case Replacement: étape 3, image 2 de 2

    • Grasp the rear case and lift it off of the front case.

    • Do not try to completely remove the rear case yet, as it is still attached by the display port ribbon cable.

    Traduire

  5. GoPro HD Hero2 Rear Case Replacement: étape 4, image 1 de 2 GoPro HD Hero2 Rear Case Replacement: étape 4, image 2 de 2

    • Using a plastic opening tool or your fingernail, flip up the locking tab on the SD board ribbon cable ZIF connector on the motherboard assembly.

    • Be careful that you are prying on the locking tab, and not the connector itself.

    • Use a pair of tweezers to remove the SD board ribbon cable from its connector on the motherboard.

    Traduire

  6. GoPro HD Hero2 Rear Case Replacement: étape 5, image 1 de 3 GoPro HD Hero2 Rear Case Replacement: étape 5, image 2 de 3 GoPro HD Hero2 Rear Case Replacement: étape 5, image 3 de 3

    • Lift the speaker out of the rear case with the tip of a spudger.

    • Remove the rear case.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 1 autre contributeur

David Hodson

Membre depuis le 04/13/10

150 493 Réputation

127 tutoriels rédigés

Badges: 53

+ 50 badges supplémentaires

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 756