Aller au contenu principal

Introduction

Follow this guide to remove the back cover on HP 15-ba0709dx laptop. This guide is a prerequisite to practically every repair and replacement that this laptop requires.

Pièces

Aucune pièce spécifiée.

  1. Flip the device over and locate the battery compartment.
    • Flip the device over and locate the battery compartment.

    • Slide the battery release latch on the left and right side until the battery is detached from its slot.

    • A noticeable pop will be heard when the battery is fully released.

  2. Pull the battery out of its slot.
    • Pull the battery out of its slot.

    • Be careful not to damage any of the connectors in the process.

  3. Place the laptop on a clean, flat surface with the bottom side facing up.
    • Place the laptop on a clean, flat surface with the bottom side facing up.

  4. Using a Phillips Head Screwdriver, remove the screws anchoring the bottom casing.
    • Using a Phillips Head Screwdriver, remove the screws anchoring the bottom casing.

    • Note: Make sure to keep track of the screws once they have been removed.

  5. Locate the screws about 1 inch from the battery release tabs and use a Phillips Head Screwdriver to remove these screws.
    • Locate the screws about 1 inch from the battery release tabs and use a Phillips Head Screwdriver to remove these screws.

    • Note:Place these newly removed screws with the ones removed in Step 2.

  6. Locate the rubber friction pads on the top corners of the laptop. Pry the pads from the laptop and place them off to the side Removing the friction pads will reveal two more anchoring screws.
    • Locate the rubber friction pads on the top corners of the laptop. Pry the pads from the laptop and place them off to the side

    • Removing the friction pads will reveal two more anchoring screws.

    • Note: The adhesive keeping the pads on the laptop will weaken once doing this, but it is necessary to removing the bottom cover of the laptop.

  7. Remove disc reader.
    • Remove disc reader.

    • Note: If all screws are removed it should slide out easily.

  8. Use a plastic prod to pry the back cover off the laptop. Be careful not to damage the laptop while prying.
    • Use a plastic prod to pry the back cover off the laptop.

    • Be careful not to damage the laptop while prying.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Lydia Brown

Membre depuis le 20/03/2017

369 Réputation

2 tutoriels rédigés

Équipe

Texas Tech, Team S13-G3, Bennett Spring 2017 Membre de l'équipe Texas Tech, Team S13-G3, Bennett Spring 2017

TTU-BENNETT-S17S13G3

5 membres

5 tutoriels rédigés

2 commentaires

Make sure to use a very thin shim, but strong enough to pry.

spotty118 - Réponse

thanks- also worked for 15-ba053nr

Renee Brandt - Réponse

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 5

30 derniers jours : 17

Total : 1,447