Introduction
Here is a HP 310-1037 with a failed hard drive. The Hitachit 1TB hard drive is a common item to fail. The repalcement is very easy and not hidden screws or adhesive. All that is needed is a flathead screwdriver and a Phillips screwdriver.
Ce dont vous avez besoin
-
-
HP310-1037 Touchsmart PC with a dead hard drive. The hard drive is located behind the stand cover.
-
Lay the PC flat on the front to gain access to the stand cover
-
Remove the single screw that holds the stand cover to the chassis with a flat tip screwdriver
-
-
-
-
Once the four screws are removed, slide the hard drive out of the caddy.
-
Here is the failed drive. It is a Hitachi HDS721010CLA332. Failure with this drive is all to common.
Where can I Get This Hard Drive? If you can e-mail me alan.becerril14@gmail.com
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
6 autres ont terminé cette réparation.
Un commentaire
This one made me laugh - Remove two screws. Pull the drive out. Difficulty: Moderate.
LOL