Ce dont vous avez besoin
-
-
HP310-1037 Touchsmart PC with a dead hard drive. The hard drive is located behind the stand cover.
-
Lay the PC flat on the front to gain access to the stand cover
-
Remove the single screw that holds the stand cover to the chassis with a flat tip screwdriver
-
-
-
Once the four screws are removed, slide the hard drive out of the caddy.
-
Here is the failed drive. It is a Hitachi HDS721010CLA332. Failure with this drive is all to common.
Where can I Get This Hard Drive? If you can e-mail me alan.becerril14@gmail.com
-
-
-
-
Remove the four Torx/Flathead screws securing the stand.
-
Lift the bottom part of the stand upwards, and it will come off.
-
-
-
Remove the four Torx/Flathead screws securing the back cover.
-
Also unscrew the two captive Philips screws securing the disc drive, as these two screws also secure the back cover.
-
-
-
Remove the seven silver Torx/Flathead screws securing the metal shield.
-
Remove the single black Torx/Flathead screw securing the metal shield.
-
Remove the cables strung through the shield.
-
Pull up on the shield to remove it.
-
-
-
Remove the two Torx/Flathead screws securing the fan.
-
Pull up on the fan connector to remove it.
-
Lift the fan to remove it.
-
-
-
Remove the six Philips screws securing the heatsink assembly to the motherboard.
-
Carefully lift the heatsink. If it won't come off, twist it as you pull it off. If it still won't come off, pull harder.
-
-
-
Remove all attached connectors from the motherboard.
-
Remove the four remaining screws securing the motherboard. You're done!
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.