Aller au contenu principal

Introduction

Use this guide to replace the WIFI card on your HP Beats Special Edition 15-p390nr. Make sure you have removed the keyboard panel by referring to the prerequisite guide.

  1. Turn computer off before starting. Turn computer over and begin removing noticeable 8mm screws with a Phillips #0 screwdriver.
    • Turn computer off before starting.

    • Turn computer over and begin removing noticeable 8mm screws with a Phillips #0 screwdriver.

  2. Some screws may be hidden under a screw cover. Simply use a metal spudger to pop off the screw cover to unveil the hidden 8mm screw.
    • Some screws may be hidden under a screw cover.

    • Simply use a metal spudger to pop off the screw cover to unveil the hidden 8mm screw.

    • Screw cover may fly when removing.

  3. Once screws are removed you may now remove the optical drive. Remove the hidden 3mm screw in the optical drive port.
    • Once screws are removed you may now remove the optical drive.

    • Remove the hidden 3mm screw in the optical drive port.

  4. Remove the rubberized feet located on the left and right shoulder of the computer to uncover hidden 8mm screws. Popping noises are normal
    • Remove the rubberized feet located on the left and right shoulder of the computer to uncover hidden 8mm screws.

    • Popping noises are normal

  5. Batteries pour ordinateurs portables

    Une réparation facile pour un gain en puissance max.

    Acheter maintenant

    Batteries pour ordinateurs portables

    Une réparation facile pour un gain en puissance max.

    Acheter maintenant
  6. Flip computer over and wedge metal spudger along the computer to pop off keyboard panel Flip computer over and wedge metal spudger along the computer to pop off keyboard panel
    • Flip computer over and wedge metal spudger along the computer to pop off keyboard panel

  7. Unclip wires connected to the motherboard and remove keyboard from the device. 17 screws should be removed up to this point.
    • Unclip wires connected to the motherboard and remove keyboard from the device.

    • 17 screws should be removed up to this point.

  8. Once the keyboard panel is removed you will need to locate the WiFi card
    • Once the keyboard panel is removed you will need to locate the WiFi card

  9. Remove two screws using the Phillips #0 screwdriver.
    • Remove two screws using the Phillips #0 screwdriver.

  10. Remove wire connected to the back of the card by pulling it straight up.
    • Remove wire connected to the back of the card by pulling it straight up.

  11. Pull card away from you to remove it from the motherboard.
    • Pull card away from you to remove it from the motherboard.

    • Refrain from wiggling or moving the card around, while connected to the motherboard, to prevent damage to connector pins.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Evan Rice

Membre depuis le 02/10/2018

425 Réputation

3 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 7

Total : 112