Introduction
This guide walks through replacing a faulty camera. It requires removing the keyboard mount and lid. Afterwards, this guide requires a plastic opening tool and recommends tweezers to finish removal.
Ce dont vous avez besoin
-
-
Flip the laptop upside down so that the lid lies flat on the table.
-
Remove the nine 6mm Phillips #00 screws that line the border.
-
-
-
-
Gently tug on the black and white wires connected to the Wi-Fi module to disconnect them.
-
-
-
Use the plastic opening tool to pry the left and right side of the top of the lid, and proceed inwards from the sides.
-
-
-
Gently remove the slide-out connector near the bottom left corner of the camera mount.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
3 autres ont terminé cette réparation.