Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the side case door by pushing towards the rear of the device with your hand.
-
Once you slide the door back, remove it by pulling it outwards from the device.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the side case door by pushing towards the rear of the device with your hand.
-
Once you slide the door back, remove it by pulling it outwards from the device.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the IDE data and power cables from the hard drive.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the front bezel by pulling upwards and out from below the lowest air vent.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the external drive faceplate by removing the two Torx T15 screws.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the following screws:
-
Front Torx T15.
-
Torx T15 mounting the hard drive cage to the optical drive bay.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Fully remove the hard drive cage by sliding it towards the back of the device and pulling down.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the two Torx T15 screws holding this side of the hard drive in place.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Proceed to the other side of the hard drive cage.
-
Remove the two Torx T15 screws holding this side of the hard drive in place.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the hard drive from the hard drive cage by pulling it outward from the cage.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Release the lower portion of the RAM by pushing down on the bottom tab.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Release the upper portion of the RAM by pushing down on the upper tab.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the RAM by pulling it out towards the side of the device
-
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.