Introduction

The front-facing camera is an important of any modern tablet or laptop . This guide shows how to replace a broken or malfunctioning webcam on the HP Elite x2 1012 G2.

Make sure the device is turned off before starting.
  • Make sure the device is turned off before starting.

  • Orient the device so the back is facing you, with the kickstand up.

Ajouter un commentaire

Remove the six 3mm Torx T5 screws underneath the kickstand.
  • Remove the six 3mm Torx T5 screws underneath the kickstand.

Ajouter un commentaire

  • Turn the device over so the screen is facing you.

  • Place a suction cup firmly onto a corner of the screen.

  • Lift up gently until you see the screen separate from the casing.

  • Repeat this process for all four corners.

Ajouter un commentaire

  • Lift the screen up and off of the device.

  • Pry each corner up first, otherwise you may damage or crack the screen.

Ajouter un commentaire

  • Remove the two connectors on the back of the screen by lifting the connector tabs on the motherboard with a plastic opening tool and pulling gently.

Ajouter un commentaire

  • Remove the screen by gently lifting it off of the device.

Ajouter un commentaire

  • Orient the device so that the battery is closest to you.

  • The battery is the large, black rectangle at the bottom of the device.

Ajouter un commentaire

  • Remove the wire connector to the front webcam using a plastic opening tool. Hook the tool underneath the connector and pull up and back.

Ajouter un commentaire

  • Remove the connector immediately to the left of the front webcam's connector. Use a plastic opening tool to gently lift the connector up and out.

Ajouter un commentaire

  • Remove the connector immediately to the right of the front webcam's connector. Use a plastic opening tool to gently lift the connector up and out.

Ajouter un commentaire

  • Use a Phillips screwdriver to remove the Phillips M2.0x2.0 screw to the left of the webcam. Turn the screwdriver counterclockwise to remove the screw.

Ajouter un commentaire

  • Remove the webcam using a plastic opening tool to lift it up and off.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Noah Stapp

Membre depuis le 18/04/2018

416 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team S18-G5, Livingston Spring 2018 Membre de l'équipe Cal Poly, Team S18-G5, Livingston Spring 2018

CPSU-LIVINGSTON-S18S18G5

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 6

30 derniers jours : 19

Total : 61