Introduction

The scanner piece is a part of the printer that scans over a paper. It may become misaligned or damaged over time. This guide will help a user replace the scanning piece.

Open the cartridge access area.
  • Open the cartridge access area.

Ajouter un commentaire

Remove the three 11.5 mm screws with a T10 bit.
  • Remove the three 11.5 mm screws with a T10 bit.

Ajouter un commentaire

  • Locate the cover hinge on the right side of the printer.

  • Pull the hinge off of the scanner to allow the scanner to open to 90 degress.

Ajouter un commentaire

  • Remove the 12 mm screws on the left side of the printer with a T10 bit.

Ajouter un commentaire

  • Remove the 11.5 mm screw with a T10 bit to release the spring-loaded hinge.

  • Since this is a compression spring, the hinge will snap downwards as soon as it is loosened.

Ajouter un commentaire

  • Pull the plastic side cover off of the printer.

  • You may need to lift the printer and push the cover downwards as it is latched onto the bottom of the printer.

  • Plastic opening tools or a metal spudger may also be used.

Ajouter un commentaire

  • Remove the five 11.5 mm screws located at the bottom of the scanner.

  • Steps 3-6 were intended to create easier access to these screws. However, they will still be difficult to reach.

  • The top of the scanner will now easily pull off.

Ajouter un commentaire

  • Pry the old scanning glass up with a metal spudger.

  • There are adhesives under the scanning glass. Be careful not to break the glass while removing it.

Ajouter un commentaire

  • The scanning piece is located in the bottom half of the scanner that was not separated from the printer.

  • Lift the scanning piece and detach the ribbon cable by gently pulling on it.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Ryan Steakley

Membre depuis le 23/01/2018

766 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team S1-G6, Livingston Winter 2018 Membre de l'équipe Cal Poly, Team S1-G6, Livingston Winter 2018

CPSU-LIVINGSTON-W18S1G6

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 8

Total : 68