Introduction

Most of the replaceable components in a laptop is through the back panel. Therefore, this guide will show how to remove it properly.

Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.
  • Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.

Ajouter un commentaire

Use a Torx T5 head to remove the six 5.1 mm screws.
  • Use a Torx T5 head to remove the six 5.1 mm screws.

  • Use a JIS J1 to remove the two 7.2mm screws.

Ajouter un commentaire

  • Use Plastic opening tool to pry open the case. Go slowly around the edge. You will hear popping noises, such are due to popping open the small joints that keep the cover attached.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Matthew Martin

Membre depuis le 10/10/2017

501 Réputation

5 tutoriels rédigés

Équipe

USF Tampa, Team S13-G17, Cagle Fall 2017 Membre de l'équipe USF Tampa, Team S13-G17, Cagle Fall 2017

USFT-CAGLE-F17S13G17

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 27

Total : 277