Menu 

Vos paramètres

Mon établi

Accédez rapidement aux tutoriels, aux pièces et aux réponses correspondant à vos appareils
Mon panier (US Store)

On dirait que votre panier est vide

Parcourez notre boutique

HP Mini 1000 Keyboard Replacement

Rédigé par : Walter Galan (et 4 autres contributeurs)
  • Commentaires : 0
  • Favoris : 2
  • Réparations terminées : 5

Difficulté

Modérée

Étapes

6

Temps nécessaire

15 - 30 minutes

Sections

2

Drapeaux

0

Introduction

Replace the keyboard in your HP Mini 1000.

Outils

Acheter ces outils

Pièces

Aucune pièce spécifiée.

  1. With the case closed, place the Mini 1000 top-side down on a flat surface. Push both of the battery release latches toward each other.

    • With the case closed, place the Mini 1000 top-side down on a flat surface.

    • Push both of the battery release latches toward each other.

    Traduire

  2. Lift the battery out of the Mini 1000 from the edge closest to the release latches.

    • Lift the battery out of the Mini 1000 from the edge closest to the release latches.

    Traduire

  3. Kits pour Apple Watch

    Réparer l'écran et la batterie n'a jamais été aussi facile.

    Acheter maintenant

    Kits pour Apple Watch

    Réparer l'écran et la batterie n'a jamais été aussi facile.

    Acheter maintenant

  4. Remove the following two screws:

    • Remove the following two screws:

    • One 6 mm Phillips screw

    • One 4 mm Phillips screw

    Traduire

  5. To facilitate the removal of the keyboard, it is recommended to push the keyboard outwards with one hand through the opening (highlighted in the third picture) located on the backside of the Mini 1000. While pushing through the opening with one hand, grasp the left upper edge with the other hand and slightly pull the keyboard towards you. Once an opening has been established, grasp the keyboard and slowly lift it upwards along the upper perimeter of the top edge.

    • To facilitate the removal of the keyboard, it is recommended to push the keyboard outwards with one hand through the opening (highlighted in the third picture) located on the backside of the Mini 1000.

    • While pushing through the opening with one hand, grasp the left upper edge with the other hand and slightly pull the keyboard towards you.

    • Once an opening has been established, grasp the keyboard and slowly lift it upwards along the upper perimeter of the top edge.

    Traduire

  6. Lift the keyboard out of the upper case, minding the cable that is still connecting it to the motherboard.

    • Lift the keyboard out of the upper case, minding the cable that is still connecting it to the motherboard.

    Traduire

  7. Use your fingernail or the flat end of a spudger to flip up the retaining flap on the keyboard cable ZIF socket.

    • Use your fingernail or the flat end of a spudger to flip up the retaining flap on the keyboard cable ZIF socket.

    • Be sure you are prying up on the retaining flap, not the socket itself.

    • Pull the cable out of its socket and remove the keyboard.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

5 autre(s) ont terminé cette réparation.

0 commentaires

Ajouter un commentaire

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 3

30 derniers jours : 13

Total : 9,164