Introduction

Use this guide to replace or upgrade the single PC2-4200 RAM stick on your Mini 1000.

  1. With the case closed, place the Mini 1000 top-side down on a flat surface.
    • With the case closed, place the Mini 1000 top-side down on a flat surface.

    • Push both of the battery release latches toward each other.

    Ajouter un commentaire

  2. Lift the battery out of the Mini 1000 from the edge closest to the release latches.
    • Lift the battery out of the Mini 1000 from the edge closest to the release latches.

    Ajouter un commentaire

    • Before proceeding, slide the right battery release latch to the unlocked position nearest the center of the computer.

    • Use the tip of a spudger to slide the RAM compartment cover release latch away from the center of the computer.

    • At this point, the edge of the RAM compartment cover nearest the battery compartment should pop up from the lower case.

    Ajouter un commentaire

    • Remove the RAM compartment cover from the lower case.

    Ajouter un commentaire

    • Use your fingers to simultaneously pull both RAM retaining arms away from the center of the RAM chip.

    • The RAM chip should pop up slightly from its socket.

    • Pull the RAM chip out of its socket and remove it from the Mini 1000.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 4

30 derniers jours : 19

Total : 3,700