Aller au contenu principal

Introduction

The keyboard in the HP Mini 110 is held in by three screws behind the battery, and will easily pop out with a little clever work with the spudger. Removing the keyboard is a must if you need to access any of the internals (except for the memory).

Pièces

Aucune pièce spécifiée.

  1. HP Mini 110-1046NR Keyboard Replacement, Battery: étape 1, image 1 de 3 HP Mini 110-1046NR Keyboard Replacement, Battery: étape 1, image 2 de 3 HP Mini 110-1046NR Keyboard Replacement, Battery: étape 1, image 3 de 3
    • Power-off the netbook fully before attempting to remove the battery.

    • Flip your netbook upside down, and locate the sliding tabs near the battery.

    • Slide both tabs inward so that the battery visibly moves away from the case of the computer.

    • Release the tabs and pull the battery out.

  2. HP Mini 110-1046NR Keyboard Replacement, Keyboard: étape 2, image 1 de 2 HP Mini 110-1046NR Keyboard Replacement, Keyboard: étape 2, image 2 de 2
    • With the screen closed, turn your netbook around so that the battery slot is facing you.

    • Remove the three 2.9mm screws in the battery slot.

    • This step can be made easier by using a magnetic screwdriver.

  3. HP Mini 110-1046NR Keyboard Replacement: étape 3, image 1 de 3 HP Mini 110-1046NR Keyboard Replacement: étape 3, image 2 de 3 HP Mini 110-1046NR Keyboard Replacement: étape 3, image 3 de 3
    • Flip the netbook upright, and open the screen as far as it will go.

    • Pry up the keyboard from the middle of the top edge.

    • Insert the flat end of the spudger between middle of the the top edge of the keyboard and the plastic frame behind it.

    • Pry the keyboard up until it pops out or until you can grab it with your fingers, and then pull gently until it pops out on both sides.

    • Do not pull the keyboard out immediately - there is a potentially fragile ribbon cable that attaches to the motherboard behind the keyboard.

  4. HP Mini 110-1046NR Keyboard Replacement: étape 4, image 1 de 3 HP Mini 110-1046NR Keyboard Replacement: étape 4, image 2 de 3 HP Mini 110-1046NR Keyboard Replacement: étape 4, image 3 de 3
    • Flip the keyboard over (toward you) by pivoting it about the lower edge, and lay it upside down on top of the touchpad area to reveal the ribbon cable.

    • Lightly pull up on the black tab on top of the keyboard ribbon cable until it hinges toward you and releases the ribbon cable end.

    • Pull the ribbon cable backward and out of the receptacle. This should not require any effort.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autres ont terminé cette réparation.

Amos Hine

Membre depuis le 18/10/2013

1 239 Réputation

7 tutoriels rédigés

Équipe

Clemson, Team 14-1, Benson Fall 2013 Membre de l'équipe Clemson, Team 14-1, Benson Fall 2013

CLEM-BENSON-F13S14G1

3 membres

12 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 5

Total : 6,348