Introduction

The scanner head is necessary for copying and faxing. Follow the guide to replace this crucial part.

There is a hidden screw underneath the model sticker on the front panel.
  • There is a hidden screw underneath the model sticker on the front panel.

  • Peel the model sticker off the cover.

  • This will expose the T10 screw securing the panel.

Ajouter un commentaire

Remove the single 12mm-T10 screw securing the front panel to the printer body.
  • Remove the single 12mm-T10 screw securing the front panel to the printer body.

  • Loosen the panel cover from the printer body.

  • There is a ribbon cable connected to the backside of the cover. Disconnect the cable before separating the panel completely.

Ajouter un commentaire

  • Gently remove the No-Fuss ribbon cable from the front panel.

Ajouter un commentaire

  • Remove the seven 8mm screws using the Torx T6 screwdriver.

  • Remove the motherboard from the front-panel housing.

  • The LCD display is on the opposite side.

Ajouter un commentaire

  • Lift the hood of the printer.

Ajouter un commentaire

  • Remove the two T10 11mm screws.

Ajouter un commentaire

  • Remove the panels covering the power brick and cord.

Ajouter un commentaire

  • Remove the cord from the power supply.

Ajouter un commentaire

  • Slide the power supply out from the chassis.

  • The power supply is still attached; don't pull too quickly.

Ajouter un commentaire

  • Remove final cable from power supply.

Ajouter un commentaire

  • Remove eight T10 1mm screws from the top hood of the printer.

Ajouter un commentaire

  • Use the nylon spudger to pry the tab.

  • Lift up the entire panel.

Ajouter un commentaire

  • Lift and flip the entire panel.

  • Be aware of the scanner head attached to the panel.

Ajouter un commentaire

  • Start with the scanner head in place.

  • Unwind the ribbon from the track.

  • Detach ribbon completely.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Maya Willis

Membre depuis le 24/01/2018

340 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team S18-G3, Livingston Winter 2018 Membre de l'équipe Cal Poly, Team S18-G3, Livingston Winter 2018

CPSU-LIVINGSTON-W18S18G3

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 10

Total : 82