Introduction

To gain access to the motherboard, the CMOS battery, and the power supply of your HP Officejet Pro 8625, use this guide to remove the left side panel. You will need a T9 Torx screwdriver for each screw in this guide.

Pièces

Aucune pièce nécessaire.

  1. Remove the two 11.6 mm T9 screws from the right side of the back of the printer. Remove the two 11.6 mm T9 screws from the right side of the back of the printer. Remove the two 11.6 mm T9 screws from the right side of the back of the printer.
    • Remove the two 11.6 mm T9 screws from the right side of the back of the printer.

  2. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  3. Pull down the front panel to expose the screws on the front. Remove the one 11.6 mm T9 screw on the left side of the front face. Remove the one 11.6 mm T9 screw on the left side of the front face.
    • Pull down the front panel to expose the screws on the front.

    • Remove the one 11.6 mm T9 screw on the left side of the front face.

  4. Remove the side panel by pushing down and towards the back. This step may be easier if the printer is laid on its side with the left side panel facing up.
    • Remove the side panel by pushing down and towards the back.

    • This step may be easier if the printer is laid on its side with the left side panel facing up.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Daniel

Membre depuis le 08/10/2018

229 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team S13-G3, White Fall 2018 Membre de l'équipe Cal Poly, Team S13-G3, White Fall 2018

CPSU-WHITE-F18S13G3

3 membres

7 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 3

Total : 44