Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the back panel by inserting your fingers into the indentations next to the tabs. Press the tabs inward towards each other while pulling the back panel toward you.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using the T10 Torx Security Bit Screwdriver, unscrew the screws on the upper left and right corners of the inner panel to remove the inner back panel.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Press down on the two plastic hinges to remove the upper portion of printer.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Grasp the plastic plug on the end of the speaker wire, then gently pull the plug away from the printer until the wire is removed.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Rotate the printer so the paper tray is facing towards you.
-
Gently lift the scanner tray up and away from the printer.
-
Press the gray plastic tabs inward to release the tabs from the printer.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Returning to the back of the printer, remove the scanner from the back hinges.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Gently grasp and unplug the two white ribbon cables from the printer body.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Unplug the white plastic multi-wire connector (with orange, black, red, and brown wires) from it's port.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Detach the scanner tray from the printer by lifting the scanner tray off the printer body.
-
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.