Aller au contenu principal

Introduction

The case contains all the internal parts of the laptop. It will need to be opened to replace these parts. This guide will serve as a general procedure on how to open up the laptop case in order to perform the other replacement guides.

  1. Unplug laptop  from adapter and all other devices.
    • Unplug laptop from adapter and all other devices.

  2. Flip the laptop over with battery facing you.
    • Flip the laptop over with battery facing you.

  3. Slide the battery lock on the right side open. Slide the Battery release latch on the left side.
    • Slide the battery lock on the right side open.

    • Slide the Battery release latch on the left side.

  4. Pull battery out.
    • Pull battery out.

  5. Batteries pour ordinateurs portables

    Batteries pour toutes les grandes marques d'ordinateurs portables. Qualité assurée par notre garantie.

    Acheter maintenant

    Batteries pour ordinateurs portables

    Batteries pour toutes les grandes marques d'ordinateurs portables. Qualité assurée par notre garantie.

    Acheter maintenant
  6. Remove the two 6.5mm Phillips #1 keyboard screws from bottom of laptop.
    • Remove the two 6.5mm Phillips #1 keyboard screws from bottom of laptop.

  7. Push screwdriver through screw hole top  pop the keyboard.
    • Push screwdriver through screw hole top pop the keyboard.

    • Make sure the screen is open.

  8. Pry up the keyboard.
    • Pry up the keyboard.

    • The keyboard is still attached by it's ribbon.

  9. Remove keyboard  wire  by popping latch under blue  plastic
    • Remove keyboard wire by popping latch under blue plastic

  10. Using the spudger to lift up on the white  tabs
    • Using the spudger to lift up on the white tabs

    • Pull horizontally on the blue ribbon to disconnect the cables

  11. Remove the five 5.5mm Phillips #1 screws from the case
    • Remove the five 5.5mm Phillips #1 screws from the case

  12. Remove eight 6.5mm Phillips #1 screws from the back cover
    • Remove eight 6.5mm Phillips #1 screws from the back cover

  13. Starting at a top corner, use the pry tool to split the case. Slowly work around the case, pulling up gently to release the clips. Slowly work around the case, pulling up gently to release the clips.
    • Starting at a top corner, use the pry tool to split the case.

    • Slowly work around the case, pulling up gently to release the clips.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Shaw Bacon Graveline

Membre depuis le 13/02/2018

142 Réputation

1 tutoriel rédigé

Équipe

USF Tampa, Team S11-G2, Cheng Spring 2018 Membre de l'équipe USF Tampa, Team S11-G2, Cheng Spring 2018

USFT-CHENG-S18S11G2

4 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 4

Total : 96