Aller au contenu principal

Introduction

This guide will show you the procedure how to remove and reset your RAM on the motherboard if it has become damaged and no longer works and needs to be replaced or may have become disconnected or loose.

Pièces

Aucune pièce spécifiée.

  1. Unplug laptop  from adapter and all other devices.
    • Unplug laptop from adapter and all other devices.

  2. Flip the laptop over with battery facing you.
    • Flip the laptop over with battery facing you.

  3. Slide the battery lock on the right side open. Slide the Battery release latch on the left side.
    • Slide the battery lock on the right side open.

    • Slide the Battery release latch on the left side.

  4. Pull battery out.
    • Pull battery out.

  5. Remove the two 6.5mm Phillips #1 keyboard screws from bottom of laptop.
    • Remove the two 6.5mm Phillips #1 keyboard screws from bottom of laptop.

  6. Push screwdriver through screw hole top  pop the keyboard.
    • Push screwdriver through screw hole top pop the keyboard.

    • Make sure the screen is open.

  7. Pry up the keyboard.
    • Pry up the keyboard.

    • The keyboard is still attached by it's ribbon.

  8. Remove keyboard  wire  by popping latch under blue  plastic
    • Remove keyboard wire by popping latch under blue plastic

  9. Using the spudger to lift up on the white  tabs
    • Using the spudger to lift up on the white tabs

    • Pull horizontally on the blue ribbon to disconnect the cables

  10. Remove the five 5.5mm Phillips #1 screws from the case
    • Remove the five 5.5mm Phillips #1 screws from the case

  11. Remove eight 6.5mm Phillips #1 screws from the back cover
    • Remove eight 6.5mm Phillips #1 screws from the back cover

  12. Starting at a top corner, use the pry tool to split the case. Slowly work around the case, pulling up gently to release the clips. Slowly work around the case, pulling up gently to release the clips.
    • Starting at a top corner, use the pry tool to split the case.

    • Slowly work around the case, pulling up gently to release the clips.

  13. Disconnect motherboard cable from left side USB and jacks Disconnect motherboard cable from left side USB and jacks
    • Disconnect motherboard cable from left side USB and jacks

  14. Remove the six 5.5mm Phillips #1 motherboard screws
    • Remove the six 5.5mm Phillips #1 motherboard screws

    • Remove the one 3.5mm Phillips #1 screw from the WiFi chip

  15. Remove motherboard.
    • Remove motherboard.

  16. With the mother board removed flip it upside down.
    • With the mother board removed flip it upside down.

  17. Pull the clips attaching the ram outwards.
    • Pull the clips attaching the ram outwards.

    • Remove ram at a angle.

    • Do not force the RAM loose, this can break the RAM or motherboard

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Sam Barkley

Membre depuis le 13/02/2018

959 Réputation

8 tutoriels rédigés

Équipe

USF Tampa, Team S11-G2, Cheng Spring 2018 Membre de l'équipe USF Tampa, Team S11-G2, Cheng Spring 2018

USFT-CHENG-S18S11G2

4 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 8

Total : 71