Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Pièces & Outils

Introduction

The battery of the HP Pavilion is made to last for only a period of time, after which the battery tends to run low sooner than usual. This means the battery capacity has lessened and may need a replacement. This guide will walk you through the process of accessing the RTC Battery of an HP Pavilion dv5000 in order to replace it.

Pièces

Aucune pièce spécifiée.

  1. Turn off the computer, and unplug it from all external power sources.
    • Turn off the computer, and unplug it from all external power sources.

    • Lay the computer face-down on a flat surface. Orient the computer to match the image.

    • Locate the battery release switch, as indicated in the image by the red rectangle. Slide the switch from right to left, and remove the battery.

  2. Remove the two 5mm Phillips screws on the right side of the RAM cover. Lift the right side of the RAM cover, and remove it. Lift the right side of the RAM cover, and remove it.
    • Remove the two 5mm Phillips screws on the right side of the RAM cover.

    • Lift the right side of the RAM cover, and remove it.

  3. Manta Precision Bit Set

    112 embouts pour toute réparation.

    Upgrade Your Toolbox

    Manta Precision Bit Set

    Upgrade Your Toolbox
  4. Disconnect the antenna leads from the wifi card by lifting the gold ends of the wires off the prongs on the wifi card. The white wire connects to the AUX terminal.
    • Disconnect the antenna leads from the wifi card by lifting the gold ends of the wires off the prongs on the wifi card.

    • The white wire connects to the AUX terminal.

    • The black wire connects to the MAIN terminal.

  5. Remove the two 6.0mm Phillips screws from the wifi card. Remove the wifi card.
    • Remove the two 6.0mm Phillips screws from the wifi card.

    • Remove the wifi card.

  6. Remove the RTC Battery from the battery holder. Remove the RTC Battery from the battery holder. Remove the RTC Battery from the battery holder.
    • Remove the RTC Battery from the battery holder.

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autre(s) ont terminé cette réparation.

Farid Khoshnevissan

Membre depuis le 11/10/2010

757 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 21-34, Regan Fall 2010 Membre de l'équipe Cal Poly, Team 21-34, Regan Fall 2010

CPSU-REGAN-F10S21G34

4 membres

11 tutoriels rédigés

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 1

7 derniers jours : 11

30 derniers jours : 40

Total : 10,399